Sökning: "3D-modelling"
Visar resultat 11 - 15 av 114 uppsatser innehållade ordet 3D-modelling.
11. Timmerknuten - ett grundrecept
Kandidat-uppsats, Göteborgs universitet/Institutionen för kulturvårdSammanfattning : This thesis shows constructive relationships that are required for a log joint to make a tight seal and to be constructively reasonable. At the same time, the thesis clarifies where it is possible to be constructively and aesthetically creative in its design. LÄS MER
12. Assessing the potential impacts of tall buildings on a predominantly low-rise built urban environment : A case study from Västerås, Sweden
Magister-uppsats, Umeå universitet/Institutionen för geografiSammanfattning : Tall buildings have been constructed in many cities over the world to accommodate the demographic and economic growth in urban areas. These structures, however, have been widely discussed concerning their potential negative impacts on urban life. LÄS MER
13. Imaging of the MTP joint: Developing an imaging protocol optimised for damage detection and 3D modelling
Master-uppsats, KTH/FysikSammanfattning : Walking without pain in the toe has a significant impact on a person’s well-being. Human mobility will be impaired in osteoarthritis of the big toe, and pain will occur during walking. By replacing the cartilage or bone injury with an individualised implant, osteochondral injuries to the knee and ankle can be treated. LÄS MER
14. Semi-Automatic calculation of the stability of shear walls in multi-storey buildings
Uppsats för yrkesexamina på avancerad nivå, Lunds universitet/Avdelningen för KonstruktionsteknikSammanfattning : Performing horizontal stability analysis in the conceptual design phase is time consuming and adjustments in the geometry of the building require new time consuming calculations. Often buildings are modelled in 3D modelling software such as Revit and Tekla but the calculations are often performed in a separate software. LÄS MER
15. CFD Optimization of Hydrofoiling Concept for A New Era of Sea Transports
Master-uppsats, KTH/Lättkonstruktioner, marina system, flyg- och rymdteknik, rörelsemekanikSammanfattning : The aim of this master thesis is to develop and optimize the main wing of a T-shaped hydrofoil for a small passenger vessel called FoilCart. The project is in collaboration with KTH Maritime Robotic Lab. The existing prototype of the hydrofoil is built by a company called ZPARQ\cite{Zparq}, but the efficiency of the main wing is not optimized. LÄS MER