Sökning: "C maskinteknik"
Visar resultat 1 - 5 av 40 uppsatser innehållade orden C maskinteknik.
1. Optimering av paketdistributionen på ett fallföretags pakettransportrutt
M1-uppsats, Högskolan i Gävle/Avdelningen för industriell ekonomi, industridesign och maskinteknikSammanfattning : Internal transportation is one of the key elements in manufacturing operations, and there is a constant need to optimize this process (Antoniuk, 2021). The case company has a very large industrial are covering 3 km2, which poses significant challenges for the internal transportation. LÄS MER
2. Effects of Temperature and Moisture Content on Young’s Modulus in Glass Fiber Reinforced Polyamide
Uppsats för yrkesexamina på avancerad nivå, Blekinge Tekniska Högskola/Institutionen för maskinteknikSammanfattning : This thesis was made in cooperation with Roxtec. Roxtec specialises in cable sealingsolutions and are world leading in their area. In many of Roxtec’s products steel isused in the frame holding the sealing rubber. To lower Roxtec’s environmental foot-print plastic would be used instead in the frames if possible, more specific polyamide6. LÄS MER
3. Dimensionering av matning för nyskänkugn hos SSAB i Oxelösund
Uppsats för yrkesexamina på grundnivå, Högskolan Väst/Avdelningen för Industriell ekonomi, Elektro- och MaskinteknikSammanfattning : SSAB i Oxelösund ska bygga en ljusbågsugn för konvertering av verksamheten från huvudsakligen malmbaserad produktion till skrotbaserad produktion. I samband med byggandet av ljusbågsugnen kommer en ny 130 kV linje byggas och från denna linje kommer ett nytt 30 kV nät byggas för att mata ljusbågsugnen och två stycken skänkugnar. LÄS MER
4. EB-PBF additive manufacturing of Alloy 718 : Effect of shot peening on surface characteristics and high temperature corrosion performance
Magister-uppsats, Högskolan Väst/Avdelningen för Industriell ekonomi, Elektro- och MaskinteknikSammanfattning : There is an upsurge of research interest on Alloy 718 additively manufactured (AM) by electron beam powder bed fusion (EB-PBF) technique in aero and land-based gas turbine engines. However, the surface quality of the manufactured components has always been a major challenge. LÄS MER
5. Electron Beam - Powder Bed Fusion Of Alloy 718 : Influences Of Contour Parameters On Surface And Microstructural Characteristics
Uppsats för yrkesexamina på avancerad nivå, Högskolan Väst/Avdelningen för Industriell ekonomi, Elektro- och MaskinteknikSammanfattning : Additive Manufacturing (AM) is an uprising manufacturing process for parts with complex geometries and low production quantities. Within the layer-wise building process, less additional processes are needed, to produce the parts. This allows a building of parts within a reasonable time- and costs-range. LÄS MER