Sökning: "PI controller"
Visar resultat 11 - 15 av 122 uppsatser innehållade orden PI controller.
11. Evaluation of MPC and PI control on a Tribometer : Design and comparison of control methods for a Pin-on-Disc Tribometer
Master-uppsats, KTH/Skolan för industriell teknik och management (ITM)Sammanfattning : This thesis compares Model Predictive Control (MPC) and Proportional-Integral (PI) control in a pin-on-disc tribometer. The tribometer consists of a geared Direct Current (DC) motor driving a flywheel and a voice coil actuating a pin onto the surface of the flywheel. LÄS MER
12. Improvement and verification of a pin-on-disc tribometer with variable speed and load
Master-uppsats, KTH/Skolan för elektroteknik och datavetenskap (EECS)Sammanfattning : The use of threaded fasteners can be found throughout the manufacturing industry due to their simplicity. When tightening a threaded fastener, the goal is to reach a desired clamping force. However, the clamping force is not directly measurable in production environments and the tightening torque is instead used to estimate the clamping force. LÄS MER
13. Design and Simulation of a 10kW High-Efficiency Dual Active Bridge Converter
Master-uppsats, KTH/Skolan för elektroteknik och datavetenskap (EECS)Sammanfattning : The EU has proposed an ambitious goal to achieve widespread E-mobility in both the electrical and commercial sectors. To accomplish this, a substantial number of DC fast-charging stations must be built. LÄS MER
14. Modelling and Control of the Steering in an Articulated Forklift using Rapid Control Prototyping
Master-uppsats, Linköpings universitet/ReglerteknikSammanfattning : This report focuses on the steering of a Very Narrow Aisle (VNA) forklift, which undergoes frequent transitions between manual and wire guidance modes. Manual operation is employed outside narrow aisles, while wire guidance mode is utilized within them. LÄS MER
15. Dynamic Torque Control of Brushed DC Motors for Hardware-in-the-Loop Integration
Uppsats för yrkesexamina på avancerad nivå, Lunds universitet/Institutionen för reglerteknikSammanfattning : The main goal with the thesis was to design, construct and evaluate a system able to drive and brake a mechanical axis to simulate loads and stored rotational energy - a hardware force simulator. The force simulator was then to be integrated in a existing hardware-in-the-loop testing rig to enhance the mechanical dynamics of door simulations. LÄS MER