NUMERICAL MODELLING OF A NOVEL PVT COLLECTOR AT CELL RESOLUTION

Sammanfattning: Solar photovoltaic-thermal (PVT) modules produce heat and power via a heat exchanger attached to the rear of the PV cells. The novel PVT collector in this study is previously untested and therefore its behaviour and thermo-electric performance due to fluid channel configuration and in various climate and operating conditions are unknown. Moreover, the working fluid flowing through the heat exchanger cause a temperature gradient across the module such that a cell near the inlet and a cell near the outlet may have significant temperature differences. PV cells are sensitive to temperature; however the most common way to simulate power output from a PVT is to use the average temperature and ignore the gradient. In this study, a single diode PV model is incorporated into a commercial thermal solver to co-simulate the thermal and electrical output of a novel PVT module design with cell level resolution. The PVT system is modelled in steady state under various wind speeds, inlet temperatures, ambient temperatures, flow rates, irradiation, convection coefficients from coolant and back of the module and two different fluid channel configurations. The results show that of the controllable variables, the inlet temperature has the highest influence of the total power output and that a parallel flow of the fluid channel configuration is preferable. The difference between the cell resolution and the module resolution simulations do not motivate the use of a higher resolution numerical simulation.