This is a report for a bachelor degree thesis in electronics at Umeå university. The target was to design a fully functional PCB-layout and then solder components to it. In order to do that I had to first proofread a schematic of the system to find things that were not correct and correct them. The project is a cooperation between the author and the company Calmon Stegmotorteknik. During the whole project the people at Calmon supported the author with the appropriate knowledge to complete the tasks. The proofreading of the schematic resulted in a couple of corrected errors. The layoutdesign went well and the design is now sent to a PCB manufacturer. Unfortunately the soldering of components did not fit into the timeframe of the project.
HÄR KAN DU HÄMTA UPPSATSEN I FULLTEXT. (följ länken till nästa sida)