Testbänk för luftlager

Sammanfattning: Test bench for air bearings This thesis work consisted of bringing forward and defining the test parameters relevant for a test bench and constructing a test bench that can test and verify the largest existing air bearings that are of use in Micronic Laser Systems AB machines. Because the knowledge about air bearings is limited it is thought that with the help of the test bench the knowledge would increase and in that way improve the air bearings. After learning more about air bearings and their purpose at Micronic Laser Systems AB, I started the concept phase for the test bench. For each part in the test bench I consulted my two tutors, Torbjörn Hedevärn and Johan Bergqvist, at Micronic Laser Systems AB. The final concepts where documented as 3D-modells in Solidworks and some of them have been tested in Solidworks FEM-program. The test bench is designed so that, with the help of a pneumatic cylinder, 25 kilo weights are placed on the air bearing to test its stiffness, damping and the pressure performance under its surface area. To test these parameters the test bench has to have a pressure meter, accelerometer and a microcator. It is also designed with the safety aspect in view. For example it has a two hand controller system that minimizes the risk of getting stuck between the pneumatic cylinder and the 25 kilo weights.