Circuit analysis of a parallel plate waveguide

Sammanfattning: The aim of this work was to model a four-port waveguide as a simple circuit,by first starting with a two-port then a three-port waveguide. Duethat the work was based on Nathan Marcuvitz book Waveguide handbook,an analytical solution for the circuit parameters was desired. In order toobtain an analytical solution three methods were studied; the Variationalmethod, the Integral equation method and the Static method. Out of thesethree methods the latter was chosen, because its strength of simplifying theboundary conditions. The goal to model a four-port and a three-portedwaveguide was too complicated. This led to that the goal was changed totrying to get a higher accuracy on the existing circuit model for a two-portwaveguide, by solving an extension to the circuit parameter. This was donebecause Marcuvitz only treated the first two modes correctly and it was notclear if the circuit model was stable for the higher orders of Taylor series. Inthe end a circuit model for a waveguide with an iris that treats the first 16modes correctly was solved. By looking at the dispersive properties of thecircuit a comparison with simulation software CST Microwave Studio couldbe done, which resulted in that the circuit model gave good results up to2b/ < 1. It was also showed that the accuracy was about the same as thecircuit model found in Waveguide handbook, but it can be mentioned thatthe accuracy is minimally better for the circuit model that was developed inthis work. Something that was discovered in this work is that the restrictionmentioned in Waveguide handbook for the case when the window is centeredis unreliable, it should be 2b/ < 1. It also appeared that the circuit modelremained stable for higher orders of the Taylor series, in this case up to the16:th order.