Electrochemical microsensor with in-situ fabricated Ag/AgCl reference electrode for high-pressure microfluidics

Sammanfattning: Electroanalysis offers cheap and selective analysis of interesting solutions. However, one of the most common drawbacks is the accessibility for electrochemical sensing. By using high-pressure microfluidics with an integrated three-electrode system, new possibilities open for increased accessibility. Therefore, there is a need to fabricate sustainable reference surfaces into highly pressure tolerant microchannels. In this thesis, Ag/AgCl reference surfaces were in-situ fabricated in high-pressure microfluidic chips. This was performed by electroplating Ag on thin film Pt in microchannels and then chlorinating the silver into Ag/AgCl. Electroanalysis of ferrocyanide was carried out in a microfluidic chip using one of the in-situ fabricated Ag/AgCl references. The half-wave potential showed to be around +251 mV and the electrochemical water window was measured to 1400 mV with a range between -300 mV and +1100 mV. The obtained values show to be comparable to reference data of similar experiments performed elsewhere. For some applications of electrochemistry, a catalysis surface is beneficial. Nanoporous Pt black has proved to generate high catalytic performance in electrochemistry. Therefore, attempts have been carried out to fabricate Pt black onto Pt thin films, with the vision to succeed with such fabrication within microfluidic channels. To summarize, this project work has showed a possibility to in-situ fabricate Ag/AgCl reference surfaces. The project has also showed how to use such surfaces as reference electrodes for electroanalysis in high-pressure microfluidic chips. Lastly, new challenges and ideas to fabricate catalysis surfaces on thin film electrodes in flow channels have been presented. By this thesis, one more step has been taken to increase the accessibility for electroanalysis.