Non-intrusive Logging and Monitoring System of a Parameterized Hardware-in-the-loop Real-Time Simulator

Sammanfattning: Electronic Control Unit (ECU) is a crucial component in today’s vehicle. In a complete vehicle, there are many ECUs installed. Each of these controls a single function of the vehicle. During the development cycle of an ECU, its functionality needs to be validated against the requirement specification. The Hardware-in-the-loop (HIL) method is commonly used to do this by testing the ECU in a virtual representation of its controlled system. One crucial part of the HIL testing method is an intermediary component that acts as a bridge between the simulation computer and the ECU under test. This component runs a parameterized real-time system that translates messages from the simulation computer to the ECU under test and vice versa. It has a strict real-time requirement for each of its tasks to complete.A logging and monitoring system is needed to ensure that the intermediary component is functioning correctly. This functionality is implemented in the form of low priority additional tasks that run concurrently with the high priority message translation tasks. The implementation of these tasks, alongside with a distributed system to support the logging and monitoring functionality, is presented in this thesis work.Several execution time measurements are carried out to get the information on how the parameters of a task affect its execution time. Then, the linear regression analysis is used to model the execution time estimation of the parameterized tasks. Finally, the time demand analysis is utilized to provide a guarantee that the system is schedulable.