Enhancing the Decoding of Short LDPC Codes with Stochastic Sequences

Sammanfattning: Low-Density Parity-Check (LDPC) codes are one of the most popular codes used in nowadays’ communication due to their high coding efficiency at low decoding complexity. With these characteristics, LDPC codes are suitable for high-speed information transmission systems. The widely used decoding algorithm for LDPC codes is Belief Propagation (BP) decoding with which the performance of LDPC codes can approach the Shannon limit. With the development of 5G, a lot of attention is given to the so-called ultra-reliable low latency communication scenario which needs the short code to transmit. However, short codes will not have a very good performance with BP decoding. To solve this problem, investigations have been done such as multiple-bases BP decoding. Although this decoding method has a better performance than BP decoding, it will cause a high complexity in the hardware implementation. Besides, an investigation on the stochastic decoding for shortcodes was proposed in 2003. This decoding method is hardware friendly, but its performance can only approach BP decoding. Inspired by multiple-bases BP decoding and stochastic decoding, binary stochastic decoding with parallel decoders is proposed in this thesis firstly. It represents stochastic sequences with multiple parallel Tanner graphs and uses hard-decision decoding in the iterative part because of the binary input bits. However, this decoding method has a severe performance loss compared to BP decoding. To avoid this problem, the enhancement method is used to make the binary sequences be non-binary sequences that can form more powerful parallel decoders. Then the non-binary symbols of these new sequences are transformed to their corresponding log-likelihood ratio which enables the iterative part to use BP decoding. In addition, combining with the ML decision of list decoding, the decision part of our stochastic decoder can fully utilize the output to increase the efficiency of the decoding method. After ensuring the performance of our non-binary stochastic decoding to be better than BP decoding, the complexity of the decoder is reduced to save the computational resources. Finally, with constant adjustments, the bit width of each non-binary symbol is determined to be 15, and the sequence length is reduced to 20 which can let the non-binary stochastic decoding has an acceptable complexity while keeping good performance.