Sökning: "Bearing’s Stiffness"
Visar resultat 1 - 5 av 12 uppsatser innehållade orden Bearing’s Stiffness.
1. Fan-wall modifications : Improving Vibrations
Kandidat-uppsats,Sammanfattning : FläktGroup is one of the world’s largest supplier of products and solutions related to indoor climate control. The Jönköping location is the largest production facility for FläktGroup. Air handling equipment for commercial buildings are the company's major products, while ventilation and air treatment are its primary business. LÄS MER
2. Fibre volume fractions’ and printing directions’ effects on tribological and mechanical properties in FDM printed carbon fibre reinforced PEEK : Suitability assessment of FDM printed PEEK-CF to act in a steam engine’s ball joint, by analysis of compressive properties, impact strength, friction and wear
Master-uppsats, Karlstads universitet/Institutionen för ingenjörsvetenskap och fysik (from 2013)Sammanfattning : The purpose with this study was to investigate FDM/FFF manufactured carbon fibre reinforced PEEK and assess its suitability to act as a sealing- and bearing material in a modern steam engine’s ball joint. The steam engine is totally free from oil due to the risk of water- and steam contamination. LÄS MER
3. Multibody modelling of the vibrations in an aircraft engine
Master-uppsats, KTH/Lättkonstruktioner, marina system, flyg- och rymdteknik, rörelsemekanikSammanfattning : During the assembly of aircraft engines, some clearance is left in the rolling bearings mainly to reduce friction. However this clearance might allow the rolling element to vibrate during flight. Indeed, unwanted vibrations called non-synchronous vibrations (NSV) appear on the data recorded by the sensors on some development engines. LÄS MER
4. Virtual verification and improvement of innovative wind turbine gearbox design
Master-uppsats, KTH/Skolan för industriell teknik och management (ITM)Sammanfattning : Cascade Drives develops electromechanical linear actuators based on multiple pinions interacting with a gear rack. With a patented load sharing mechanism, that uses flexible torsional elements, the torque is equally distributed among the pinions. LÄS MER
5. Dynamic Analysis of an Automotive Power Transfer unit : Towards prediction of TE and housing vibrations
Master-uppsats, KTH/Maskinkonstruktion (Avd.)Sammanfattning : This work describes the use of Multi-Body Simulation (MBS) to create a virtual prototype of a geared drive called Power transfer unit (PTU). PTU is a subsystem of the all-wheel drive driveline responsible for transfer of power between front and rear axles in an Automobile. LÄS MER