Sökning: "Assembly process"
Visar resultat 6 - 10 av 673 uppsatser innehållade orden Assembly process.
6. Konceptstudie kring snabb-fästen för skärutrustning till en motorsåg
M1-uppsats, Jönköping University/JTH, Industriell produktutveckling, produktion och designSammanfattning : This report describes a thesis project together with Husqvarna Group at the Advanced Development Handheld department. The aim of the project was to develop a prototype for a more efficient rapid bar exchange for one of Husqvarnas chainsaws. The reason for this is that the current design for changing the bar and chain is time consuming. LÄS MER
7. Analog mixed signal front-end for Torque signal processing : A theoretical noise analysis and signal-chain evaluation
Kandidat-uppsats, KTH/Skolan för elektroteknik och datavetenskap (EECS)Sammanfattning : High precision tightening of nuts and bolts together with traceability are important in many industrial assembly lines. To achieve this the nutrunner needs to accurately measure the torque which is applied to the nut, process the signal and provide the information to the controller that controls the tightening process. LÄS MER
8. Produktutveckling av en solcellsställning
M1-uppsats, Mälardalens universitet/Akademin för innovation, design och teknikSammanfattning : The market for large-scale solar parks is growing rapidly. The Swedish government has set goals to incorporate a larger amount of renewable electricity in the Swedish energy mix. To achieve this, new solar parks are being built in various locations throughout Sweden. LÄS MER
9. Structural Analysis and Redesign of a L90 Front Axle Casing
Uppsats för yrkesexamina på avancerad nivå, Luleå tekniska universitet/Institutionen för teknikvetenskap och matematikSammanfattning : This thesis was commissioned by Volvo Construction Equipment (Volvo CE) to redesign the front axle casing of their L90 wheel loader to be more in line with their larger wheel loaders. The current L90 front axle casing consists of two parts bolted together in the middle. LÄS MER
10. Automatiserad limning av kullager : Framtagning av station för automatiserad limning
M1-uppsats, KTH/ProduktionsutvecklingSammanfattning : Projektet gick ut på att utveckla ett antal koncept för att automatisera limningen av ett kullager som monteras i underdelen med hjälp av en kollaborativ robot. De ser detta som vägen framåt mot en mer effektiv produktion. Målet var att ta fram tre koncept för hur detta kan ske samtidigt som kraven upprätthålls. LÄS MER