Sökning: "general electric"
Visar resultat 6 - 10 av 198 uppsatser innehållade orden general electric.
6. Tools and Challenges in Evaluating Control Surface Airworthiness for a Blended-Wing-Body UAV
Master-uppsats, KTH/Lättkonstruktioner, marina system, flyg- och rymdteknik, rörelsemekanikSammanfattning : For transport aeroplanes the Blended-Wing-Body (BWB) configuration shows promise in improving aerodynamic efficiency. The Green Raven project strives to demonstrate hydrogen fuel-cell-electric propulsion on a 4 m wingspan BWB. LÄS MER
7. Analysis of high-voltage low-current DC/DC converters for electrohydrodynamic pumps
Kandidat-uppsats, Uppsala universitet/Institutionen för elektroteknikSammanfattning : Moving parts cause vibrations and tend to wear out. In applications where maintenance is complicated, solutions without moving parts are therefore advantageous. Electrohydrodynamic pumps are such a solution. Instead of mechanical propulsion, they use strong electric fields to induce movement in a dielectric cooling liquid. LÄS MER
8. Outlook of EV battery pack design trends : Assessment of trend impact from a recycling perspective
Kandidat-uppsats, KTH/Skolan för industriell teknik och management (ITM)Sammanfattning : Electrification is essential to decarbonise the transport sector, which accounts for the highest share of greenhouse gas emissions by all sectors. The transition requires a large amount of batteries which bring challenges, not least when it comes to raw material supply and sustainability issues during the mineral mining. LÄS MER
9. Cavity Beam Position Monitors State of the Art and Design Studies in the Context of the ILC Project
Master-uppsats, Lunds universitet/Partikel- och kärnfysik; Lunds universitet/Fysiska institutionen; Lunds universitet/Lunds Tekniska HögskolaSammanfattning : The aim of this master thesis project is the study and evaluation of the design of cavity beam position monitors (BPM) for the International Linear Collider (ILC) project. The state-of-the-art of BPMs is investigated to determine the most appropriate existing BPM design for the requirements of the ILC. LÄS MER
10. Developing an Ar milling process to improve the contact quality to InAs nanowires
Kandidat-uppsats, Lunds universitet/Fysiska institutionen; Lunds universitet/Fasta tillståndets fysikSammanfattning : The aim of this work was to develop a stable and reproducible argon milling process for InAs nanowires to remove the native oxide layer that increases electrical resistance. This was done by identifying a few milling parameters and studying them in relation to the milling rate of silicon dioxide (SiO2). LÄS MER