Sökning: "in-plane loading"
Visar resultat 1 - 5 av 15 uppsatser innehållade orden in-plane loading.
1. Rate-dependent effects on the mechanical behaviour of paper
Master-uppsats, KTH/HållfasthetsläraSammanfattning : It is established that paper properties depend on the loading rate. The rule of thumb is that the in-plane strength and stiffness increases about 10\%, when the strain rate increases by a factor of 10. Converting of paperboard into packages requires creasing of the paperboard followed by folding to make 3 dimensional packages. LÄS MER
2. Validation of An Iteration Free Material Model for Paperboard (NEO)
Uppsats för yrkesexamina på avancerad nivå, Lunds universitet/Hållfasthetslära; Lunds universitet/Institutionen för byggvetenskaperSammanfattning : The NEO model, developed by Lindström (2019) for paperboard, is a non-linear material model that utilizes empirically based constitutive relations with switches to mimic elastic-plastic responses. Due to the explicit definition of the constitutive relations, the NEO model does not require a constitutive equilibrium loop. LÄS MER
3. In-plane bi-axial testing of thin paper
Master-uppsats, KTH/HållfasthetsläraSammanfattning : During its lifetime, a beverage package is subjected to a complex loading history where the loading, in general, is multiaxial. Hence, to optimize the performance of the package, knowledge of the material’s anisotropic multi-axial deformation and subsequent failure is necessary. LÄS MER
4. Multiscale mechanical modeling of paperboard
Uppsats för yrkesexamina på avancerad nivå, Lunds universitet/Hållfasthetslära; Lunds universitet/Institutionen för byggvetenskaperSammanfattning : This thesis considers an investigation into the possibilities of creating a reasonably accurate multiscale material model for paperboard, with geometry based on X-ray scans of small paperboard samples. The modeling takes place in the software Multiscale Designer by Altair Engineering Inc. LÄS MER
5. CHARACTERISATION OF CROSS LAMINATED TIMBER PROPERTIES
Uppsats för yrkesexamina på avancerad nivå, Lunds universitet/Byggnadsmekanik; Lunds universitet/Institutionen för byggvetenskaperSammanfattning : This project concerns an analysis of a hitherto untested method for determining the modulus of elasticity (MoE) and shear modulus parallel to grain, as well as the rolling shear modulus of cross laminated timber (CLT) through 3-point bending tests. A review of analytical models and methods is included, followed by an evaluation of the effect of the annual ring orientation and shear stress distribution at shear loading of individual board cross-sections. LÄS MER
