Sökning: "fluid grids"
Visar resultat 1 - 5 av 15 uppsatser innehållade orden fluid grids.
1. Computational Fluid Dynamics of the flow in a diffuser : - like geometry
Kandidat-uppsats, KTH/Skolan för teknikvetenskap (SCI)Sammanfattning : Simulations were performed to investigate flow separation of an asymmetricdiffuser - like geometry. The geometry used for the simulations was modeledafter an experimental setup with recorded flow data, which was compared tothe simulated data. For all simulations, steady state flow at the inlet was usedwith the assumption of a 2D flow. LÄS MER
2. Accelerated Testing of the End-plate Assembly of a Redox Flow Battery
Master-uppsats, KTH/Skolan för industriell teknik och management (ITM)Sammanfattning : As the world transitions to intermittent renewable energy sources like solar and wind, the need for long-duration energy storage technologies is becoming more and more prominent. In this regard, flow batteries are seen as a promising solution, owing to their inherent advantages like decoupling of power and energy, extremely high cycle life and negligible self-discharge. LÄS MER
3. Geometrical Improvement of Fuel Nozzle Locations in the SGT-750 Gas Turbine : An investigation into fuel-air mixing in main channels 1 & 2
Master-uppsats, Linköpings universitet/Mekanisk värmeteori och strömningsläraSammanfattning : This study was conducted on SGT-750, which utilizes can type fourth generation DLE burner, developed at Siemens Energy AB, in Finspång, Sweden. The aim of this study is to obtain a flat fuel profile at the outlet of main channel 1 and main channel 2, demonstrating a proper mixing of fuel and air in the main channels leading to reducing local high-temperature points, and thus, reducing thermal NOx emissions. LÄS MER
4. Omkonstruktion av bockverktyg : Från hydraulisk till elektrisk drivning
Uppsats för yrkesexamina på grundnivå, Uppsala universitet/Industriell teknikSammanfattning : A hydraulic bending tool is used in the manufacturing of transformer windings at Hitachi ABB Power Grids. This tool is used to create a pitch between the turns in the winding, a process which demands very strict tolerances during bending. Hitachi/ABB believes that the current tool is quite inconvenient and, in some cases, dangerous to use. LÄS MER
5. Aerodynamic Performance Analysis of a UAV using CFD and VLM
Master-uppsats, Linköpings universitet/Mekanisk värmeteori och strömningsläraSammanfattning : Computational Fluid Dynamics has become a versatile product development tool, bringing many advantages to the conceptual design phase of products, and is being used for a wide variety of applications. In this thesis, the aerodynamics of a UAV with internal radar has been investigated. LÄS MER